The particle detector/portable particle counter uses the International Hypothetical Retardation (Frost) method of International Hydraulic Standards and is designed for rapid detection of the level of contamination of fluids in the field. They have the advantage of small size, light mass, fast speed, high accuracy and good repetitiveness, and can work under high temperature and high pressure, among other conditions. Microwater sensors and temperature sensors are built in and can be detected with water content and fluid temperature at the same time as contamination. They apply to oils such as engine oils, gear oils, transformer oils (i.e., insulation oils), hydraulic fluids, lubricants and synthetic oils, and are widely applied in areas such as aerospace, petrochemicals, traffic ports, steel metallurgicals and car manufacturing. I. Particle detector/portable particle meter instrument characteristics, photoresist (shield) method
Frozen gas analyzers are equipment for measuring the flue content of CO2, CO, NOx, SO2, etc., using continuous analysis of electrochemical sensors. Mainly for small-scale fuel, gas boilers or hand-held use for environmental monitoring near sources of pollution. Zhejiang Highpower Environmental below will provide a brief introduction to the typical flue gas analyzer malfunctions and the treatment methods.
On-line continuous monitoring system (highly low concentration) of pneumatic and industrial process measurements for wet scrubbers • The entire system includes extraction and pre-treatment systems, And the laser pre-scatter duster system has an automatic control function. And all the key components have a test function • Application of corrosive flue gas below acid dots can select corrosion resistant components • System-wide non-movement components • Waiting for smoke to be pumped, The PM-1820WS is used to measure particulate emissions from the installation of wet scrubbers and other processes that are below the dew point (cool flue condition) or have water droplets. The extraction system extracts typical smoke from the pipe continuously, heating up to
As smoke from combustion, including some other sources of pollution, is more polluting to the environment if it is released into the air with impunity, the environmental sector is now more stringent in this regard, and businesses are operating without being fined by the environmental sector and are operating on a continuous monitoring system. So how do you choose a test system like horseback? It's the only way to be able to function properly in the process.
